HP+ Oil Pump & Cam Plate Kit. M8 2017up – Oil Cooled Models
$1,203.00 RRP (inc GST)
25400133A, 62400178, FE-7096, SS310-0998A
M8 engines must check clearance on front exhaust lifter to camshaft flange fit
HP+ Pump & Camplate Kit, Gear or Chain drive, M8 17up (Oil Cooled engines)
* If using gear drive cams, Block-off Plate part # FE-8016 is required
* Kit Includes a billet 6061 aluminum high volume oil pump & FEULING HIGH FLOW camplate.
PRODUCT DETAILS :
Kits increase oil pressure, oil volume, engine oil flow and return oil scavenging
Quieter and smoother engine operation
27% more pressure and scavenge gear volume over stock
42% more scavenge volume through port sizing, matched passages and holes to the engine case
68% more oil volume to the crankshaft and connecting rod bearing
15-25 degree cooler engine temperatures
15-30 degree cooler oil temperatures
10-30 more PSI of oil pressure
Reduces wet sumping, blow by and oily air cleaners
Test results show2 HP gain and 2 ft/lbs of TQ gain to the rear wheel on Milwaukee Eight
NOTE: FEULING test results show as much as 50% reduction of engine sump oil level.
Both HP+® and RACE SERIES® kits include FEULINGS® HIGH FLOW billet camplate made from 7075 aluminum which is 50% harder and stronger than the factory or Feuling OE+ camplates. FEULING® increases oil flow and volume by enlarging the oil pump reservoirs and critical oil passages including matching the oil port holes throughout the camplate to the port holes in the engine case which increases engine oil flow to the lifters, piston cooling jets, crankshaft and rod bearings.
The FEULING oil pumps are bench tested, the relief valve is seated and sealed to a minimum of 30 psi with full pop off at 55-60 psi. The increased oil volume from the larger gears and properly sized passages along with the pressure relief valve seat and seal from these oil pumps is essential for proper oiling system function. The FEULI
MFR PART No: 7196
ROLLIES PART No: FE-7196